Amendements aux règles de Classe RSX.
Depuis le 1er janvier, les regles de jauges RSX ont évoluées comme le précise l'amendement ci dessous:
1°) concernant les footstraps, plus de marque imposée, le choix est libre, seul le nombre de strap et de vis est précisé
2°) le cover de dérive pryde n'est plus obligatoire, si elle est utilisée une simple protection de derive de 25mm de large sur 135 mm de long fera l'affaire, en utilisant les trous de fixation existants.
3°) les palans sont libres et des poulies peuvent être rajoutées à l'oeillet de point d'écoute de la voile.
Amendments to the Class Rules 1st January 2007
06/03/2007 22:36
INTERNATIONAL RS:X CLASS ASSOCIATION
The following amendments to the Class Rules have been approved to be
effective 1st January 2007.
Rule C.6.1 (b)
Current Position: “Not less than 5 or more than 9 Footstraps supplied by the
licensed manufacturer, shall be fitted to the existing inserts using any stainless
steel screws and round washers with a maximum dimension of 17mm.
Footstraps shall be fitted with a minimum of one screw at each end.”
Amendment: Amend existing Class Rule C.6.1 (b) to read:
“A maximum of 9 and a minimum of 5 foot straps shall be fitted to the existing inserts
using any stainless steel screw and washer. Foot straps shall be fitted with at least
one screw and washer at each end “
Rule C.6.3 (g)
Current Position: “The centerboard trailing edge protector shall not be
removed.”
Amendment: Delete current rule and replace with the following:
“C.6.3 (g) The centreboard trailing edge protector may be replaced with a
webbing retaining strap not less than 25mm wide and not less than 135mm long.
The strap if used shall be fixed by a screw into an existing screw hole located
each side of the centreboard slot.”
Rule C.6.3 (i)
Current Position: Not Applicable
Amendment: New Rule to read as follows:
“The centreboard hull gasket screw holes may be filled and faired.”
Rule C.8.2 (g)
Current Position: An adjustable outhaul supplied by the licensed manufacturer
shall be used.
Amendment: Delete the current rule and replace with the following:
“Any adjustable outhaul system as supplied by the licensed manufacturer shall
be used. Blocks may be fitted to the clew of the mainsail.”
